Advertisement
Table of Contents
Below are steps to install, configure and test the H-531, H-831 and M-560
Telex USB Microphones.
These steps were written for Windows 98, and Windows 98 Second Edition.
The steps are the same for both editions. Depending on your computer, the
installation may or may not go through all of the installation steps. Your
computer may go through many of the steps without prompting you. Be sure to
follow this manual carefully to confirm that you have successfully installed the
device.
The H-531, H-831and the M-560 install the same way. Two device drivers will be
loaded, the USB Composite Device and the USB Audio Device. The USB Audio
Device may also appear as the Telex USB Microphone. The drivers for the USB
Composite and USB Audio Device/USB Microphone are found in the Windows
operating system. Note: You do not need an installation disk for either
microphone.
NOTE: The H-531 is a headworn microphone, not a headset. There is no
speaker in the earpiece. The foam cushion is for comfort only.
1. Installation
a. Plug the microphone directly into an USB port on your computer.
b. The Add New Hardware wizard will detect the USB Composite Device.
To begin installing the USB Composite Device, click Next.
c. Select the option to let Windows Search for the Best Available Drivers
and click Next.
d. Select the option to Specify a Location and type in c:\windows in the
pathway and click Next.
e. Windows should find the driver and install it. Click Next to install the
driver. Note: the location of the driver is c:\windows\inf\usb.inf.
f. After Windows has completed installing the USB Composite Device, click
Finish.
After the USB Composite Device has been installed, the computer will start to
install the USB Audio Device. Note: the USB Audio Device may also appear as
the Telex USB Microphone
g. The Add New Hardware wizard will start up again and look for the USB
Audio Device, click Next.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Telex H-531
Summary of Contents for Telex H-531
- Page 1 The H-531, H-831and the M-560 install the same way. Two device drivers will be loaded, the USB Composite Device and the USB Audio Device. The USB Audio Device may also appear as the Telex USB Microphone.
- Page 2 Click on the blue microphone. This will bring up a volume control slider. For a H-531, slide the volume all the way to the top. For a H-831, adjust the volume a few dashes from the top.
- Page 3 Frequently Asked Questions Why can’t I hear out of the H-531 earpiece? The H-531 is a microphone only. It has no speaker in the earpiece; the cushion is for comfort only. It recorded in Sound Recorder great the first time but not the second,...
- Page 4 Sometimes you will need to do all three items to correct the problem. Can I use the microphone in a hub? Telex will not guarantee our products performance through third party hardware. For best results, you should plug the microphone into an USB port...
Need help?
Do you have a question about the H-531 and is the answer not in the manual?
Questions and answers