Installation - Kingtel KT-4126M Owner's Instruction Manual

13.Message Waiting/Ringing
Indicator........................................... Will flash when the unit has message
14. .............................. .. In on-hook status, press and hold for 3
15.Flash................................................ For PBX use.
16.Dialing Key (0-9, ,#).......................Dial numbers and extensions.
17.CLID or ......................................Review caller IDs. Also can be used
within the menu to select telephone
settings.
18.Speaker............................................Ringer sound was spread from here.
19.Wall Mounting Hook.........................Turn 180 degrees to hang up the
handset when the unit is mounted on
the wall.
20.Hook O n/Off S witch..........................Press t o e nd a c all.
21.Handset H ook...................................When t he u nit is mounted on the wall,
this is used to hang up the handset
without hanging up the line.
22 23 24
22.E/F Switch........................................Switch between Earth & Flash.
23.Message Waiting Switch..................Switch from SR/HV/PR1/PR2.
24.Line Cord Jack................................. Connects telephone to wall.
25
5
headset mode. Press to talk or to
end the call.(This function is only
for KT-4126MH model.)
waiting information or when it is ringing.
seconds to adjust the ringer volume.
While using the speakerphone / handset
/ headset, press the keys to adjust the
speakerphone / handset / headset
volume.
26 27
25.DATA PORT(RJ11)...........................Used to connect the phone to the
26.Headset Jack(2.5mm/RJ10).............This port is only available for
27.Handset Jack

INSTALLATION

1.Open the battery compartment cover and load 4 AA batteries.
2.Connect one end of coil cord to the jack in the handset and connect the
other end in the jack of the base unit.
3.Plug one end of phone line to the line jack in the base unit and connect the
other end to the wall jack.
Plug into Cord Socket
Note:
1.Use only the following type and size batteries:AA cell Um3. The proper
polarity or direction must be observed.
2.Please change your batteries every 8 months.
3.When replacing batteries, all batteries should be changed at the same time.
4.Please pull out the line cord, when replacing batteries.
5.The phone set works well with line power alone. Batteries are only needed
for the clock to function accurately.
computer.
KT-4126MH model.
Plug into TEL
Module Jack
Phone Line
6