Advertisement
Safety instructions
Please read and follow these safety guidelines in order to maintain safety of operators and people
around:
Alarm system S-PIR has radio transceiver operating in GSM900 and GSM1800 bands.
•
Don't use the system where it can be interfere with other devices and cause any potential danger.
•
Don't use the system with medical devices.
•
Don't use the system in hazardous environment.
•
Don't expose the system to high humidity, chemical environment or mechanical impacts.
•
Don't attempt to personally repair the system. Any system repairs must be done only by qualified,
•
safety aware personnel
The system must be powered by power supply source should not exceed 15VA power supply which
•
must be approved by LST EN60950-1 standard
Any additional device connected to the S-PIR system must be powered up by a LST EN60950-1
•
approved supply.
•
Mains power must be disconnected before any installation or tuning work starts. The system
•
installation or maintenance must not be done during stormy conditions.
The system must be used only with approved back-up battery to avoid fire or explosion hazards.
•
Special care must be taken connecting positive and negative battery terminals.
Electrical socket from which the system is powered must be in an easily accessible place.
•
The device is powered by a backup battery. The device is switched off by unplugging external
•
electrical power supply and disconnecting battery connector which is ac- cessed by opening device
frame cover.
Fuse F1 type - C1S 2.5A. Blown fuse cannot be replaced by the user and the replacement fuses have
•
to be exactly the same as indicated by the manufacturer.
WARNING: in order to avoid fire or explosion hazards the system must be used only with approved
•
back-up battery. Special care must be taken when connecting positive and negative battery
terminals
The WEEE (Waste Electrical and Electronic Equipment) marking on this product (see left)
or its documentation indicates that the product must not be disposed of together with
household waste. To prevent possible harm to human health and/or the environment,
the product must be disposed on in an approved and environmentally safe recycling
process. For further information on how to dispose of this product correctly, contact
the system supplier, or the local authority responsible for waste disposal in your area.
Manufacturer declares that this GSM Alarm System S-PIR is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
External power supply can be connected to AC mains only
inside installation room with automatic 2-pole circuit
breaker capable of disconnecting circuit in the event of
short circuit or over-current condition. Open circuit
breaker must have a gap between connections of more
than 3mm.
Advertisement
