Under- And Overvoltages In The Mains Supply; Loss Of A Phase In The Mains Supply; Ordering Numbers - Kemppi Pro 3200 EVOLUTION Operation Instructions Manual

7.3.

UNDER- AND OVERVOLTAGES IN THE MAINS SUPPLY

Primary circuits of machine are protected against sudden, transient overvoltages.
Machine is designed to withstand 3 x 440 V voltage continiously (see technical data). See to
it that voltage is kept within admissble limits especially when mains supply is taken e.g. from
combusition engine generator.
If the mains has undervoltage (under approx. 300 V), machine control stops to operate automa-
tically.
7.4.

LOSS OF A PHASE IN THE MAINS SUPPLY

Loss of a phase causes noticeable poorer welding properties than normally or the machine
doesn't get started at all. Loss of a phase can be due to following:
- blowing of mains supply fuse
- defective mains cable
- bad connection of mains connection cable on terminal block or plug of machine
8.

ORDERING NUMBERS

Pro 3200 Evolution
Pro 4200 Evolution
Pro 5200 Evolution
Return current cable
Return current cable
Cable for MMA welding
Cable for MMA welding
PL
PX
R10
R20
Remote controlled interconnecting cable
T10
T120
P40
P40L
P30W
©
COPYRIGHT KEMPPI OY
5 m - 50 mm
5 m - 70 mm
5 m - 50 mm
5 m - 70 mm
10 m
Pro 3200 Evolution, Pro 4200 Evolution, Pro 5200 Evolution/0109 – 13
6131320
6131440
6131520
6184511
2
6184711
2
6184501
2
6184701
2
6185801
6185802
6185409
6185419
6185481
6185231
6185252
6185264
6185264L
6185262