Storage Instructions - Z-BEAST 54ZB Owner's Manual

Z - BEAST
Short Term Storage

Let engine cool before storing and do not store
near flame, high heat, and possible ignitions from
sparks.

Always clean off all flammable material as well as
grime and dirt before storage.

Never use a pressure washer and avoid drenching
the control panel, motor, engine, and hydraulic
drive pumps with water.

Wash with mild detergent and water only.

After washing the machine engage the engine at
high and let the mower run for 5 minutes.

Shut off fuel for storing or transporting.

Carefully release pressure from components with
stored energy.

Store mower only on the ground.

Do not drain fuel indoors or near a flame.

Use jack stands to support components when
required.

Always park machine on level ground and set the
parking brake when storing.

Store the machine in a clean and dry environment.

Always remove the key from the ignition.

Add a petroleum based conditioner in the gas tank
and run for 5 minutes to distribute through mower.
Rev: AUG2014

Storage Instructions

Extended Storage
In addition to the measures taken for short term
storage, the following measures should be taken for
long term storage:

Change air filter.

Make sure all fuel is drained before storing.

To ensure all fuel is drained from the mower, run
the mower until it runs out of gas before storage.

Check the spark plugs condition and pour two
tablespoons of engine oil in the spark plug holes
and leave the spark plugs off.

Cover the machine when in storage.

Remove Battery and clean terminals and cable
connectors. Store battery in a cool dry place.
Z- Beast Finish Mower
54ZB, 62ZB
28