Quickstart - Ehrlund ACOUSTIC PICKUP + PREAMPLIFIER Manual

EAP SYSTEM QUICKSTART
1. Fix the pickup to the instrument using the adhesive supplied.
Shape the adhesive into small balls about 3-4 mm in diameter
A cleaner sound.
and attach these to the corners of the pickup. Then stick the
pickup down where you want it on the instrument. For more infor-
mation, see page 6.
2. Connect the pickup to the input on the preamp.
3. Connect the output from the preamp to the amplifier/mixer.
4. The volume control on the preamp is normally set to maximum.
The volume is usually controlled by the connected amplifier/mixer.
5. If you think the sound is strange, for example due to feedback,
this may mean that the phase switch needs to be changed.
6. You may need to adjust the High/Low switch, depending on
the gain at subsequent stages. For example, if you feel that the
sound is clipped, you can try setting this switch to "Low".
7. When the preamp is not in use, disconnect the cable between
the preamp and the mixer/amplifier. The "output" jack acts as the
switch to turn the preamp on and off. When you connect a cable
to "Output", the preamp switches on automatically.
3