Micron SDR116 Quick User Manual

Explorer 100 Series – SDR116 – SMALL DIVERSITY RECEIVER -
Signal Status Indicator
:
Setting Up Procedure
(1) Connect provided RX
antenna
(semi-rigid straight & right-angled
screw-on SMA antennas)
(3)
If the battery status LED is AMBER
(to remove the audio output cable pull
Battery Status Indicator
Tri-colour
RXA 'Active'
Green
'A' Side Antenna
Input Socket
ON/OFF
Switch
Connect Audio output cable and
switch on.
replace RX battery
outer shell)
(4) Set the receiver to the required
operating frequency
(5) Interference Check
• Switch off TX
• Observe RX 'Active' signal strength indicators and listen for possible
interfering signals from other transmitters. If there is very strong
interference then change the frequency until you find a clean channel.
(6) Set the required audio output level to match input requirements of
your system.
Variable Audio Output
Line Level: 0dBV pot @max.
4-pin Hirose Audio
Mic Level: -42dBV pot @min.
Output Connector
The battery compartment is opened
by pressing the button on the back
of the unit. There is a slot for the 9V
battery to fit into.
The battery can easily be
released with the aid of the
thumb.
Quick User Guide
RXB 'Active'
Signal Status Indicator
Green
'B' Side Antenna
Input Socket
(2) Fit a PP3 9V battery, check
RX battery status LED
Please watch polarity of
battery.
Battery Life approx. 5
hours