Advertisement
If you are using a sustain pedal connected to control Rotor Speed
this allows you to set how this should operate. "Hold" means that the
Rotor Speed is fast for as long as the pedal is down and reverts back
to slow/stopped when the pedal is released (or vice versa depending
on the set pedal polarity).
"Toggle" means that the fast & slow/stopped rotor speed is cycled
each time you activate the pedal, like an on/off switch pedal.
Range: Hd - Hold, (default), tO - Toggle.
This allows you to change how the Nord C2 keyboard triggers the or-
gan sounds. When "High" is selected, you will trigger the organ sounds
before the key reaches the end of its travel. This mode closely mimics
the way a vintage tonewheel organ or a pipe organ trigger its notes.
Range: H- High (default), L- low
High trigger point
This sets the speed with which the drawbars will increase or decrease
the values when the drawbar buttons are held down.
Range: F- Fast (default), S- slow.
This sets the MIDI Channel that the swell manual on the Nord C2 trans-
mits and responds to.
Range: Off, 1-16 (default = 1)
This sets the MIDI channel that the great manual on the Nord C2 trans-
mits and responds to.
Range: Off, 1-16, (default = 2)
This sets the MIDI channel that the Bass section of the Nord C2 organ
transmits (if the Great manual is split) and responds to.
Range: Off, 1-16, (default = 3)
Low trigger point
This allows you to set if the Nord C2 keyboard and front panel controls
should control internal Programs or only send note and controller mes-
sages via MIDI. Local On is the normal "mode". In Local Off mode, the
front panel and keyboard action are transmitted via MIDI only and does
not control the internal sound(s) directly.
If the "E" mode is active, the keyboard of the C2 will transmit velocity.
Range: On (default), Off, E - External Device
Local defaults back to mode On every time the Nord C2 is pow-
ered on.
This setting specifies how the front panel's knobs and buttons are han-
dled in the MIDI communication with MIDI Control Change messages.
You can select if the panel controls and functions should either send or
receive, or both or if Control Change messages should be ignored.
Range: Sr (send & receive - default), r (receive only), S (send only),
Off
Specifies how the Nord C2 should handle MIDI Program Change mes-
sages.
Range: Sr (send & receive - default), r (receive only), S (send only),
Off
You can perform a dump of all the active Program's parameters as
MIDI Control Change messages. Press the Store button to perform the
dump.
This allows you to perform a MIDI SysEx dump of the currently selected
Program. Press the Store button to perform the dump.
This allows you to perform a MIDI SysEx dump of all the Programs in
the Nord C2. Press the Store button to perform the dump.
In the MIDI chapter, on page xx is a description on how the Nord C2
receives a Sys Ex dump.
Sets the speed setting (in the fast and slow speed modes) of the rotary
speaker simulation's treble horn.
Range: H - High, n - Normal (default), L - Low
Advertisement
