Basic operation
6
3.2 Installation of tool
3.2.1 Fit cutter into rotary tool, the knife and tool are as shown in following
drawings:
3.2.2 Adjust the protruding length of the knife top as required for specific cutting
media。
Correct
3.2.3 (1) Loosen the screw of tool carrier.
(2) Assembly the tool with knife into the tool
carrier。
(3) When the tool is in appropriate position screw
it and fix the screw。
CAUTION
Do not touch the knife top with your
finger to prevent injury .
(front view)
Knife adjusting screw
vynyl
Base paper
Too long protruding
length of knife tip
PCUT SERIES USER ' S MANUAL
(disassembly view)
Knife handle
Knife
Too short protruding
length of knife tip
Knife sheath