Sanyo SRT-8960P Service Manual page 7

1-2. TEMPORARILY SETTING UP AND CONNECTING CP-1 PWB ASSEMBLY
The following is an example of how to place and connect the main board without a jig, when repairing the CP-1 PWB assembly.
1. Place the mechanism unit and main board up side down as
a whole on a flat surface with foil side of the main board
facing up.
M-RF4QR/NA-4
Mechanism Main Unit
TM - 2 PWB
1-3. INSTALLATION OF THE FRONT PANEL
When installing the front panel to the chassis after repaires and adjustments.
1. Pressing down the door opener lever of the mechanism
main unit.
2. Set the cassette door to half-opened state as shown in Fig.
1-1-5, and install the front panel to the chassis.
M-RQ4Q/EX-5
Jutted part of
Cassette Holder
Front Panel
CP - 1 PWB Assembly ( Foil side )
PW - 1 PWB
Screws
Cassette Compartment
Cassette Door
(Position A)
2. Operete the unit using the buttons on CP-1 PWB or the
remote control.
Terminal Board
TM - 1 PWB
Note:
Opened cassette door position does not install the front
panel to the chassis.
Door Opener Lever
Cassette Door
(Position B)
– 8 –
Fig. 1-1-4
Fig. 1-1-5