Sony DAV-S500 Operating Instructions Manual page 27

Height diagram
l
R. H. LOW
Select this if the rear speakers are located in section 0.
l
R. H. HIGH
Select this if the rear speakers are located in section @.
These parameters are not available when "REAR" is set to "NO".
To specify the balance and level of the speakers
1
2
3
Press AMP MENU repeatedly to display P LEVEL on the front panel display.
Using I'//* to select T.TONE and use f/S to set T.TONE to ON.
You will hear the test tone from each speaker in sequence.
Sit in your listening position and select the item to be adjusted using q/+.
l
Items adjusted in P LEVEL
-Balance of the front and rear speakers
4
5
-Volume level of the centre and rear speakers and subwoofer
Adjust the volume level so that the volume of the test tone from each speaker sounds the
same using t/S.
The adjusted value will appear on the front panel display.
Repeat Steps 3 and 4 to adjust other parameters in P LEVEL.
If you do not operate the remote for a few seconds, the value disappears from the display
and is stored in the system.
6
Using f/+ to select T.TONE and use C/S to set T.TONE to OFF.
HBALANCE
You can vary the balance of each speaker as follows. The default adjustments are in the
parentheses.
l F I
--
(centre) (front speakers)
Adjust the balance between the front left and right speakers (You can adjust from centre,
6 steps left or right).
l R
I
--
(centre) (rear speakers)
Adjust the balance between the rear left and right speakers (You can adjust from centre,
6 steps left or right).