Fujitsu Primergy RX200 S4 Start Manual page 5

8
Confirm the settings and click [Start In-
stallation].
9
Click [Start now].
Installation starts.
1. If a message prompts you to insert Array
Controller Document & Tool CD, insert the
CD-ROM and click [OK].
2. If a message prompts you to insert Service
Pack CD-ROM, insert the CD-ROM and
click [OK].
3.
For Windows Server 2003 x64, a message
displays and prompts you to insert Startup
Disc Win64 and restart the system. Insert
Startup Disc Win64.
10
When a message prompts you to insert
the OS CD/DVD, insert the CD/DVD
and click [OK].
After files are copied, a message prompts you to
eject the CD/DVD and floppy disk.
11
Eject the CD/DVD and floppy disk and
click [OK].
The system is restarted. And setup of OS GUI and
installation of LAN utility, Service Pack, and Ac-
tive Directory are performed automatically.
8
Turning off the power and installing optional devices
Install optional devices to be installed after the OS installation.
"Chapter 6 Installing Internal Options"
1
Check that no media is inserted in the
CD/DVD drive, etc.
2
Exit the OS.
After the OS is exited, the server is automatically
turned off. When the power of the server is not off
after the OS is exited, press the power switch on the
front of the server.
3
Turn off the power supply of the periph-
eral devices such as the display.
4
Install the optional devices.
12
When a confirmation message to re-
start appears, click [Restart].
The system restarts and installs high reliability
tools.
Thus the Command Prompt windows may ap-
pear and the disappear during installation of
SreverView, the installation process is properly
proceeding.
13
Press any key when a message noti-
fies completion of installation.
14
Restart the system.
Click [Start] – [Shutdown]. Select [Restart] and
click [OK]. The system restarts.
15
Settings for the RAID management
tool (ServerView RAID).
For detailed information and the setting procedures,
refer to the manuals in Array Controller Document
& Tool CD.
- Settings of an array administrator account
- Configuration of HDD Check Scheduler
- Configuration of Battery Recalibration Scheduler
- After optional devices are installed, set the BIOS
Setup Utility as required.
For details about setting procedures, refer to the
"User's Guide Chapter 7 Configuring Hardware
and Utilities".
- If a UPS is installed, set the BIOS Setup Utility
as required. For setup procedures, refer to "User'
s Guide 4.5.3 Notes on Advanced Uninterruptible
Power Supply (UPS)".
When turning on the server again after turning it
off, wait for at least ten seconds and then press the
power switch.
If the server is turned on straight after being turned
off, an error will occur and may cause damage.
5