Table of Contents
Advertisement
Instruments and controls
Warning lamp
is
Power steering
on.
on and
Opening
accompanied by
a message in the
detection
screen.
Rear
flashing.
suspension
with pneumatic
height
correction
on when starting
or while driving.
ABS
ABS
remains on.
flashing.
DSC
remains on with
the LED in the
button (in the
dashboard) on.
indicates
system malfunction.
door not closed correctly.
abnormal difference between
the detected sill height and the
optimum sill height.
malfunction of the pneumatic
height correction.
malfunction of the anti-lock
braking system.
DSC regulation triggered.
system malfunction. E.g.: under-
inflation of the tyres.
Solution-action
The vehicle retains conventional steering without
assistance. Have the system checked by a PEUGEOT
dealer or a qualified workshop.
Check that the cab doors, the rear and side doors and
the bonnet are closed (if your vehicle is fitted with an
alarm).
In automatic correction mode: drive slowly (approximately
6 mph (10 km/h)) until the warning lamp goes off.
In manual correction mode: return the sill which is still at the
upper or lower limit to an optimum height. Chapter 3, "Rear
suspension" section.
You must stop as soon as it is safe to do so. Contact a
PEUGEOT dealer or a qualified workshop.
The vehicle retains conventional braking without
assistance but you are advised to stop. Contact a
PEUGEOT dealer or a qualified workshop.
The system optimises drive and permits improvement of
the directional stability of the vehicle. Chapter 4, "Driving
safety" section.
E.g. Check the pressure of the tyres. Have them
checked by a PEUGEOT dealer or a qualified workshop.
Advertisement
Table of Contents
