Table of Contents
Advertisement
ASSEMBLY & SETUP
2.1 ATTACHING THE ADAPTER TO YOUR IMAC
1. There are two sets of screw holes near the bottom of the NuMount VESA adapter. These
holes are used along with the shorter socket-head screws to align the NuMount VESA
adapter in the correct location on the iMac stand and to prevent the adapter from rotating.
As shown in the pictures below, the outside holes are used for iMacs with 24" screens
and larger. The inside holes are used for iMacs with screen sizes smaller than 24". Use the
included hex key to install the shorter socket-head screws in the holes appropriate for
your iMac, with the screw heads on the side of the adapter with the rubber O-ring (these
instructions use a 21.5" iMac, so the following pictures will show the screws installed in
the inner holes).
Under 24" Screen
2. Place the NuMount VESA adapter on the iMac stand as shown in the picture below, with
the screw heads facing the iMac. Bring the adapter flush with the iMac stand and then
lower the adapter until the edges of the iMac stand (represented by the dashed red lines)
contact the two screws you installed in step 1. The hole in the middle of the NuMount
VESA adapter should line up with the hole in the iMac stand. If the holes do not line up,
you may have installed the screws incorrectly in step 1.
NUMOUNT VESA ADAPTER FOR IMAC
24" Screen and Larger
2
ASSEMBLY & SETUP
Advertisement
Table of Contents
