Levelling - Bosch WAE28369GB Series Instruction Manual And Installation Instructions

Height difference between the
■
installation surface and the drain:
Min. 60 cm, max. 100 cm
You can lay the water drain hose as
follows:
Drainage into a washbasin
■
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of
scalding if you come into contact
with hot detergent solution (e.g.
when draining hot detergent solution
into a washbasin).
Do not reach into the hot detergent
solution.
Caution!
Damage to the appliance/fabrics
If the end of the drain hose is
immersed in the drained water, water
may be sucked back into the
appliance and may damage the
appliance/fabrics.
Make sure that:
– The plug does not block drainage
from the washbasin.
– The end of the drain hose is not
immersed in the drained water.
– The water drains away quickly
enough.
Drainage into a siphon
■
The connection point must be
secured using a hose clamp with a
diameter of 24-40 mm (available
from specialist dealers).
Positioning and connecting

Levelling

Level the appliance using a spirit level.
Incorrect levelling may result in intense
noise, vibrations and "wandering".
Loosen the lock nuts using a
1.
spanner, by turning it in a clockwise
direction.
Check the levelling of the washing
2.
machine with a spirit level, and
adjust it if necessary. Change the
height by turning the appliance feet.
All four appliance feet must stand
firmly on the ground.
Tighten the lock nut against the
3.
housing.
In doing so, hold the foot tight and
do not adjust its height.
The lock nuts on all four appliance
feet must be screwed tightly against
the housing.
en
33