Table of Contents
Advertisement
2.8
Monitor Connection
The server will only detect a monitor if this device is connected and powered up when the server is first booted up.
If the monitor is attached after the server has been booted up, no video display will be visible until the server is
rebooted.
Please note that use of any motherboard and graphic card HDMI outputs is not currently supported.
Section 3 Configuration
3.1 Logging into Server
Once the server has been connected to any other devices being used on the system, press the power button on the
front panel of the server.
The server will take approximately 60 seconds to boot up; during this time a blue/white progress bar will fill from left
to right. Once the server has completed booting up, the login screen will appear as below:
Figure 3.1 WaveView launch screen
WSUSA-MAN-008-001
9
Advertisement
Table of Contents
