OC Series - Automatic coffee machines Every effort has been made to ensure that the information contained in this manual is up to date and correct. However, the author, publisher or manufacturer will not accept liability for any loss or damage caused resulting from any errors in or omissions from information contained in this document.
OC Series - Automatic coffee machines Index of contents Using the dispenser ..................4 Quick start ....................4 Filling with coffee concentrate..............4 Cleaning the dispenser.................5 Power save mode:..................5 Dispenser Set-up mode:................5 Changing dispense parameters ..............6 Dispenser Calibrate mode: ................7 General Specifications ................13 - 3 -...
1. The display and lighting on the front panel will illuminate. 2. The display will show ‘Please wait’ then a name will appear on the top line (e.g. Kaffee Konzepte or AROMAT) and the word ‘Filling’ on the lower line. The machine will perform a ‘self check diagnostic’ for a couple of seconds then the water inlet valve will open and the boiler will begin to fill.
OC Series - Automatic coffee machines Prime the system with concentrate by pressing and holding the ‘STOP’ button and then briefly press the ‘Water’ button, release both buttons when you hear the pump run, the system will then run its priming function automatically When the coffee concentrate runs out, replace the BIB or can and prime as described above.
OC Series - Automatic coffee machines Changing dispense parameters 1. The display shows: Press Selection 2. Press the Selection button to be modified. The display will show (for example): Cup = Enabled 3. The selection button name is shown and if the selection button is enabled or disabled.
OC Series - Automatic coffee machines 6. Press the ‘STOP’ button to step to the coffee strength setting The display will show Strength = XX : 1 XX is a number between 10 and 50 The strength is expressed as a ratio of water to coffee concentrate e.g. 25:1 equals 25 parts water to 1 part coffee concentrate.
Page 8
OC Series - Automatic coffee machines 5. Press the ‘STOP’ button The display will show Pressing the ‘Jug’ button Preset enabled toggles between enabled and disabled. Set to Preset enabled 6. Press the ‘STOP’ button The display will show Size = XXX Press , + or - 7.
Page 9
OC Series - Automatic coffee machines 12. Wait 2 seconds, then press and hold down the ‘STOP’ button and switch the dispenser back on again. The display will show Setup Release the Stop button and the display will change to:- Press Selection 13.
Page 10
OC Series - Automatic coffee machines 16. Press the ‘STOP’ button The display will show Pressing the ‘Cup’ button Coffee enabled will enable this function and ‘Mug’ will disable it. Set to Coffee enabled 17. Press the ‘STOP’ button The display will show Pressing the ‘Cup’...
Page 11
OC Series - Automatic coffee machines 22. Fit the cleaning adapter to the BIB connector on the dispenser suction hose in the cooler unit. 23. Fill the cleaning bottle with water and place it in the cooler unit, place the metal tube of the cleaning adapter in the water in the bottle. 24.
Page 12
OC Series - Automatic coffee machines 32. When 50ml is dispensed, Press the ‘STOP’ button a few times until the display shows:- Calibrate? 33. Scroll through Setup and reset the both water and coffee to ‘Enabled’ 34. Press the ‘STOP’ button until The display shows Name of Firm XX°C...