Table of Contents
Advertisement
Spreads.qxd
11/9/07
12:19 PM
Detection
Your Detector
Signal Strength Chart
Signal
Signal
Strength = 1
Strength = 2
(Weakest Signal)
Radar Signals and Visual Displays
Type of Signal
X Band Radar
K Band Radar
Ka Band Radar
Ku Band Radar
Pop Radar Mode
22 English
Page 15
Signal
Signal
Signal
Strength = 3
Strength = 4
Strength = 5
(Strongest Signal)
Visual Display Voice
X Alert
K Alert
Ka Alert
Ku Alert
Pop Alert
Settings
Your Detector
NOTES
IntelliMute may not work with some vehicles because it cannot sense the
engine's revs. In such cases, you can reduce unwanted audio alerts by using
Auto Mute and City mode when appropriate.
NOTES
The rev point must be reset if you use your detector in a different vehicle.
NOTES
When initially choosing your IntelliMute activation point, a setting of approximately
300 to 600 RPMs above idle is recommended. You can reset the activation point
at any time to fit your individual preferences and driving style.
CAUTION
Do not attempt to set the rev point while driving. Your vehicle should be parked
and idling to avoid a collision during the process.
Set IntelliMute
After the detector is installed in your vehicle and the unit is turned on,
advance through the User Settings Programming to the Set IntelliMute
setup screen where the activation point can be set.
Setting the activation point progresses from the setup screen shown
on the User Programming Menu Guide (see page 34). From that screen:
1. Press the Mute
button to begin the setting process.
2. Press and hold the vehicle accelerator at the desired engine RPMs.
3. Press the Mute
button to complete the setting process.
The system will store the engine RPM setting and provide a completion
message on the display as well as a tone or voice message.
NOTE
If the unit is unable to sense usable pulses within three seconds or if you do not
set a rev point within 30 seconds of beginning the setup, IntelliMute will indicate
an error. If you do not try again within five seconds, it will automatically turn off.
The unit will provide corresponding messages for these conditions.
Once an activation point has been set, you can easily change it by going
directly to Set IntelliMute in User Settings Programming and repeating the
three-step setup process.
Nothing Comes Close to a Cobra
®
15
Advertisement
Table of Contents
