Assembly And Set-Up; Collar Clamp - Razor Black Label R Tec Owner's Manual

ASSEMBLY AND SET -UP
Attaching and Adjusting the Handlebars
Required Tool: 5 mm Allen wrench
1
Open the quick-release lever
and fully extend the T-bar to the
maximum height.
3
With the front wheel pointed
straight ahead and the
handlebars square to the front
wheel and the Razor logo facing
the front, tighten the clamp as
shown. Tighten securely.
4
To adjust the height of the
handlebars, open the quick-release
lever and slide the T-bar to the
desired position. Resecure the
quick release lever to lock into
place. When the T-bar is raised to
the maximum height, depress the
push button located directly below
the quick release lever to unlock
the T-bar.
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
2
Loosen the collar clamp. Insert
T-bar into the fork until it bottoms
out on the headset locknut.
Note: If necessary, carefully twist
the T-bar while pushing downward.
Note: The tension of the quick-
release lever can be adjusted by
manually tightening or loosening
the Allen bolt. Be careful not to
over-tighten. You should always
be able to open and close the
quick-release lever by hand and the
T-bar should slide freely when the
quick-release is open unless T-bar
is fully extended.
3
WARNING: Failure to
properly install and tighten the
collar clamp may cause the rider
to lose control and fall. If you are
having diffi culty understanding
these instructions, please
contact Razor Customer Service
for assistance.
WARNING: Failure to
properly secure the quick-release
lever may cause the T-bar to
telescope up or down while riding
and may cause you to lose control
and fall.