Fuel Filter Replacement - Chevrolet Kodiak 2008 Owner's Manual

4. Turn the ignition key to START for 10 to 15 seconds
at a time until your engine starts. If the engine tries
to run, but does not run smoothly, increase the rpm
a little using the accelerator pedal. This will help
force air through the system.
Your service engine soon light may come on if the
vehicle has run out of fuel. This light may stay on for a
few drive cycles after the condition is corrected, but
will eventually clear itself.

Fuel Filter Replacement

If you want to change the diesel engine fuel filter
yourself, here is how to do it:
CAUTION:
{
Diesel fuel is flammable. It could start a fire if
something ignites it, and you could be burned.
Do not let it get on hot engine parts, and keep
matches or other ignition sources away.
First, drain any water from the filter by following the
water draining procedure earlier in this section.
Your vehicle's engine should be off until the end of this
procedure.
5-18
If your vehicle has the 6.6L engine, the fuel filter is
located in the engine compartment on the driver's side
of the vehicle. If your vehicle has either the 7.2L or
7.8L engine, the fuel filters are located in the engine
compartment on the driver's side of the vehicle, and on
the driver's side frame rail in front of the fuel tank.
1. Apply the parking brake.
3. Remove the filter element. If there is any dirt on the
filter sealing surface, clean it off. Remove and reuse
the water sensor float switch located on the bottom of
the fuel filter.
4. Install the new filter element.
2. Unplug the water
sensor wire connected
to the fuel filter and
unscrew the filter
element.