Power Wheelchair Controls; Pg Drives Technology Control Systems; Transfers - Ranger Wheelchair Owner's Manual

Ranger Wheelchairs Owner's Manual

Power Wheelchair Controls

PG Drives Technology Control Systems

Your wheelchair is equipped with a VR2 or R-net electronics control system
made by PG Drives. The appendix at the end of this Owner's Manual contains
the operation instructions for the system whith which your wheelchair is
equipped.

Transfers

It is potentially dangerous to attempt unaided transfers - exceptional balance
and agility is required. To ensure safety during transfers complete the
following steps first:
1. ALWAYS TURN OFF THE CHAIR USING THE POWER BUTTON ON
THE JOYSTICK.
2. Work with your health care advisor to learn how to position your body
for maximum support, and always have assistance until you can confidently
complete the transfer process repeatedly.
3. Always engage the wheel locks by turning the chair off prior to transfer.
4. Ensure the tire pressure is appropriate and that the wheel locks engage the
tires fully.
5. Move the chair as close to the surface you are transferring to (or from) as
possible – employ a transfer board to bridge the distance if you can.
6. Rotate the front casters forward completely.
7. Make sure not to catch your legs or feet on the front frame or leg rest
assembly.
8. Remove the armrests if they might interfere with the direction of the
transfer.
9. Try to position yourself as far back into the chair as possible when
transferring into the chair.
Page 9