Advertisement
●
Use good quality leading brand batteries when charging alkaline batteries
this will result in many more recharges been possible with the batteries.
●
It is better to recharge your batteries once they are running low rather than
wait for them to be completely dead.
●
Once a battery falls below a certain voltage it will not recharge again. Dead
batteries that are left after use for long periods cannot be recharged.
●
It is recommended to charge used NiMH & NiCd batteries twice consecu-
tively (or around 8 hours) before use for a better effect.
●
DO NOT charge any deformed, damaged, rusted or leaked batteries with
the charger.
●
Make sure the charger is in the standby mode (lights off) before charging
any used batteries to prevent insufficient charging time.
●
If at first a battery will not charge, take it out of the charger and clean the
contacts on the battery and try again.
●
The unit will recharge alkaline batteries between 10- 20 times depending on
the age and quality of the battery. The amount of recharge power that can
be put into the battery will gradually diminish.
●
NiMH and NiCd rechargeable batteries will operate in there normal way for
recharging.
For details of other energy saving and innovative products from Watts
Clever please visit our website at
Product Specifications
Model •
SBC1001
Dimensions •
118 (L) x 71 (W) x 30 (H) mm
Input Voltage •
Fuse Rating •
T1A / 250V AC
Output Voltage •
Maximum Output Current •
For more detailed instructions, FAQ'S, and product support please visit our websites.
www.wattsclever.com
Tips for use
100V-240V AC 50/60 Hz 6W
DC1.7V (x 4)
350mA (x 4)
www.blog.wattsclever.com
www.wattsclever.com
Watts Clever
(International) Limited
Room 1407, 14/F,
New Victory House,
93-103 Wing Lok Street,
Sheung Wan, Hong Kong
T
+852 2815 6700
W
www.wattsclever.com
© 2011 Watts Clever
(International) Limited
All Rights Reserved
Made in China
www.support.wattsclever.com
Advertisement
