-
If input to the transmitter is at 1080p resolution, it will be output from the receiver at 1080i. When
output at 1080i, use a monitor that supports interlaced input.
Image input: Pin assignment of VIDEO IN
Composite input is only included with the transmitter.
Table 4.5.
RCA connector
Remote serial I/O: Pin assignment of SIO
The remote serial I/O is only included with the receiver.
Baud rate: 300 - 115200bps (Can be set by software.)
Table 4.6.
Remote serial I/O connector
Connector
used
1
6
Pin No.
Signal name
1
N.C.
2
RXD
3
TXD
4
DTR
5
GND
CAUTION
Communication may not be possible, if the following devices are connected:
-
Device that uses RI or DCD signals
-
Device that requires a RS-232C communication response above a certain level such as
programming during RS-232C communication
-
Device that uses control signals such as RTS and CTS for special purposes, etc.
RP-VL-S-02, RP-VL-R-02
D-SUB 9pin (MALE)
5
9
Pin No.
Signal name
6
DSR
7
RTS
8
CTS
9
N.C.
4. About Hardware
29