Using The Dust Filter (Optional Accessory) - ViewSonic PJD5151 User Manual

Dlp projector
Hide thumbs Also See for PJD5151:
Table of Contents

Advertisement

Using the dust filter
CAUTION
It is important to clean the dust filter every 100 hours after the dust filter is installed.
Be sure to turn off the projector and unplug it from power source before installing or
detaching the filter.
If your projector is ceiling-mounted or is not easily accessible, pay special attention to
your personal safety when replacing the dust filter.
Installing the dust filter
1.
Be sure to turn off the projector and unplug it from power
source.
2.
As the arrows shown to the right, fit the filter by aligning
and inserting it into the projector slots. Make sure it clicks
into place.
For first time installation:
3.
Open the OSD menu and go to the SYSTEM SETTING:
ADVANCED > Filter Settings menu.
4.
Press Enter and the Filter Settings page is displayed.
5.
Highlight Filter Mode and press
and the projector will remind you to clean the filter when the filter is in use for over
100 hours.
Set Filter Mode to On only when using the projector after the dust filer (optional accessory) is
properly attached. Failing to do so will result in a shorter lamp life.
Obtaining the filter hour information
1.
Open the OSD menu and go to the SYSTEM SETTING: ADVANCED >
Filter Settings menu.
2.
Press Enter. The Filter Settings page is displayed.
3.
You will see the Filter Hours information on the menu.
Cleaning the dust filter
1.
Be sure to turn off the projector and unplug it from power source.
2.
Press the latches on the dust filter and remove the filter from the projector.
3.
Use a small vacuum cleaner or a soft brush to sweep the dust on the filter away.
4.
Re-install the dust filter.
Resetting the filter timer
5.
Open the OSD menu and go to the SYSTEM SETTING: ADVANCED >
Filter Settings menu.
6.
Press Enter and the Filter Settings page is displayed.
7.
Highlight Reset Filter Hours and press Enter. A warning message is displayed
asking if you want to reset the filter timer.
(optional accessory)
/
to select On. The filter timer starts counting
46

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents