System Start - PCE Health and Fitness PCE-FWS 20 Manual

info@tursdaletechnicalservices.co.uk
Important Notes:
On the edge of wind direction sensor, there are four alphabet letter of "N","E","S" and "W"
representing for the direction of North, East, South and West. Wind direction sensor has to
be adjusted so that the directions on the sensor are matching with your real location.
Permanent wind direction error will be introduced when the wind direction sensor is not
positioned correctly during installation.
Wind speed sensor wire has to be inserted into the phone jacket on wind direction sensor.
Wind direction sensor wire has to be inserted into the phone jacket located on the thermo-
hygro sensor with marking of "Wind" on top.
The rain sensor wire has to be inserted into the phone jacket located on the thermo-hygro
sensor with marking of "Rain" on top.

System Start

Insert two pieces of LR6 (AA size) batteries into the transmitter, the LED located in the
middle front case of transmitter will be turned on for 4 seconds and then it will be off and start
to work normally. The transmitter will make a data transmission and then start radio
controlled time reception routine. If time signal can be detected correctly, then the LED will
start to flash 5 times indicating time signal has been found correctly. When time signal is bad
and reception is not possible, the transmitter will terminate radio controlled time reception
within one minute and resume normal mode. When there is a data transmission happened,
the LED will be on for 20ms. During radio controlled time reception period, there is no
transmission and normal transmission will only resume after time reception routine is
complete. The longest time for radio controlled time reception is 5 minutes.
After inserting the batteries into the Weather Station, all LCD segments will be turned on for a
few seconds, all possible display segments are turned on for checking.
After this, the weather station will make initial measurement and start to register the
transmitter ( the radio reception icon will be turned on). Before there is outdoor data received,
it is not allowed to touch the LCD, otherwise the outdoor sensor learning mode will be
terminated right after the touch of LCD. When outdoor transmitter has been registered, the
Touch Screen Weather Station will automatically switch to the normal display mode from
which all further settings can be performed by the user.
7