Important Notes; System Start - PCE Health and Fitness WH-1080PC Operation Manual

Important Notes:

On the edge of wind direction sensor, there are four alphabet letter of "N","E","S"and "W" representing for the
direction of North, East, South and West. Wind direction sensor has to be adjusted so that the directions on
the sensor are matching with your real location. Permanent wind direction error will be introduced when the
wind direction sensor is not positioned correctly during installation.
Wind speed sensor wire has to be inserted into the phone jacket on wind direction sensor.
Wind direction sensor wire has to be inserted into the phone jacket located on the thermo-hygro sensor with
marking of "Wind" on top.
The rain sensor wire has to be inserted into the phone jacket located on the thermo-hygro sensor with
marking of "Rain" on top.

System Start

Insert two pieces of LR6(AA size) batteries into the transmitter, the LED located in the middle front case of
transmitter will be turned on for 4 seconds, then it will be off and start to work normally. The transmitter will
make a data transmission and then start radio controlled time reception routine. If time signal can be detected
correctly, then the LED will start to flash 5 times indicating time signal has been found correctly. When time
signal is bad and reception is not possible, the transmitter will terminate radio controlled time reception within
one minute and resume normal mode. When there is a data transmission happened, the LED will be on for
20ms. During radio controlled time reception period, there is no transmission and normal transmission will
only resume after time reception routine is complete. The longest time for radio controlled time reception is 5
minutes.
After inserting the batteries into the Weather Station, all LCD segments will be turned on for a few seconds,
all possible display segments are turned on for checking.
After this, the weather station will make initial measurement and start to register the transmitter ( the radio
reception icon will be turned on). Before there is outdoor data received, it is not allowed to touch the LCD,
- 5 -