Table of Contents
Advertisement
SM41 Rev. 4.00
2.1
Introduction
Information in this section consists of: unpacking and inspection procedures, installation
procedures, post-installation checks, and installation drawings.
2.2
Unpacking and Inspection
Unpack the equipment carefully, and locate the warranty card. Inspect the unit visually
for damage due to shipping and report all such claims immediately to the carrier
involved. Note that each unit should have the following:
- NPX138 Radio
- Warranty Card
- Operator's Manual
- Release certification
Verify that all items are present before proceeding, and report any shortage immediately
to your supplier.
Complete the warranty card information, and send it to NAT when the installation is
complete. If you fail to complete the warranty card, the warranty will be activated on
date of shipment from NAT.
2.3
Installation Procedures
2.3.1
Warnings
Do not bundle any lines from this unit with transmitter coax lines. Do not bundle any
logic, audio, or DC power lines from this unit with 400 Hz synchro wiring or AC power
lines. Do not position this unit next to any device with a strong alternating magnetic
field such as an inverter or significant interference to operation will result. In all
installations, use shielded cable exactly as shown and ground as indicated.
Significant problems may result if these guidelines are not followed.
2.3.2
Cautions
All audio installations can be severely degraded by incorrect wiring and shielding, and
may result in much higher cross-talk, hum, and ground-loop interference. This should
be considered when audio wiring to and from the radio installation is performed.
Nov 10, 2003
ENG-FORM: 805-0104.DOT
PROPRIETARY AND CONFIDENTIAL TO NORTHERN AIRBORNE TECHNOLOGY LTD.
Section 2.0 Installation
← IMPORTANT!
Amendment # 3
NPX138 Panel Mount Radio Manual
Page 2-1
Nov 22, 2004
Advertisement
Table of Contents
