Table of Contents
Advertisement
1. Complete Unit
1-1. Loading ADJ
Set QV-5000SX to "PLAY" mode.
(1) Connect QV-5000SX and DOS/V PC with link cable.
(2) Execute the adjustment software shown below on PC.
DT777E
- aok
(3) During the procedure, "MEMORY ERROR#4" appears on the display of QV-5000SX but this
does not indicate malfunction.
(4) Parameter loading complete message will be displayed.
1-2. White balance · Sensitivity adjustment
1. Preparation
(1) Viewer (Kenko light box handy 5000) (Modified in order to input DC externally)
(2) Voltage regulator (Output voltage: 0 to 10 V, Output current: 0 ~ 1 A)
(3) Use two ND filter together, one ND10 and one ND20.
(4) Use two color temperature converter filter together, one LA10 and one LA20.
* Although those filters are sold at a large camera store, they are available from CASIO. Please
refer to the parts list (page 31).
2. Setting of equipment
(1) Supply 6 V to simplified viewer from voltage regulator.
(2) Turn on power of simplified viewer and leave it on for more than 30 minutes.
3. Adjustment procedure
(1) Start test mode MENU2.
• Set function switch to REC mode
• Turn POWER switch ON while pressing DISP key and Shutter button simultaneously.
• Press mode key twice
• Press flash key and menu key simultaneously.
(On display, cursor is placed on CCD RGB ADJUST)
(2) Set the filter so that center of illuminance face and center of two color temperature converter
filters are lined up.
(3) Bring lens of QV-5000SX close to the center of color temperature converter filters then stick QV-
5000SX and filters together.
(4) Press the shutter button.
(5) When RGB ADJUST COMPLETE is displayed the initialization, of white balance is completed.
(6) Remove two color temperature filters from simplified viewer.
(7) Set the filter so that center of illuminance face and center of two ND filters are lined up.
ADJUSTMENT
98042101.adj ENTER
Link cable
QV-5000SX
— 5 —
PC
RS232C port
Advertisement
Table of Contents
