Using Computer Setup (F10) Utilities - HP t620 Troubleshooting Manual

Using Computer Setup (F10) Utilities

Computer Setup can be accessed only by turning the computer on or restarting the system. To access
the Computer Setup Utilities menu, complete the following steps:
1. Turn on or restart the computer.
2. Press either
bottom of the screen.
Pressing
NOTE:
again press
NOTE:
Selection option using the
3. If you pressed Esc, press
4. A choice of five headings appears in the Computer Setup Utilities menu: File, Storage, Security,
Power, and Advanced.
5.
Use the arrow (left and right) keys to select the appropriate heading. Use the arrow (up and down)
keys to select the option you want, then press Enter. To return to the Computer Setup Utilities
menu, press Esc.
6. To apply and save changes, select File > Save Changes and Exit.
If you have made changes that you do not want applied, select Ignore Changes and
Exit.
To reset to factory settings, select Apply Defaults and Exit. This option will restore the
original factory system defaults.
CAUTION:
(F10) changes because the CMOS could become corrupted. It is safe to turn off the computer only after
exiting the F10 Setup screen.
Heading
File
Storage
Security
Power
Advanced
Esc or F10 while the "Press the ESC key for Startup Menu" message is displayed at the
Esc displays a menu that allows you to access different options available at startup.
If you do not press Esc
Esc or F10 when the monitor light turns green to access the utility.
You can select the language for most menus, settings, and messages using the Language
F8 key in Computer Setup.
F10 to enter Computer Setup.
Do NOT turn the computer power OFF while the BIOS is saving the Computer Setup
or F10 at the appropriate time, you must restart the computer and
Table
Computer Setup—File on page 34
Computer Setup—Storage on page 35
Computer Setup—Security on page 36
Computer Setup—Power on page 38
Computer Setup—Advanced on page 38
Computer Setup (F10) Utilities
33