Physical Transmitter Adjustments; Transmitter Mode Conversion; Programming Conversion; Mechanical Conversion - Spectrum DX6 Instruction Manual

Spectrum 6 channel dsmx telemetry system
Table of Contents

Advertisement

EN

PHYSICAL TRANSMITTER ADJUSTMENTS

Transmitter Mode Conversion

You can change transmitter modes among Modes 1, 2, 3 and 4.
This conversion requires both a programming and a mechanical
change.

Programming Conversion:

1. Access the System Settings menu from the Setup List and
select the desired Mode. If you are changing between Modes
2/4 or 1/3, you can STOP after Step 1.
2. Exit the System Settings menu to save the selection.
3. Power off the transmitter and remove the transmitter battery pack.
After you change the transmitter Mode in the Setup List, you will
need to make mechanical changes to the transmitter gimbals.

MECHANICAL CONVERSION

CAUTION:
Always power off the transmitter, disconnect and remove the battery before adjusting stick tension or friction straps. Not
doing so could result in property damage or injury.
Mechanical conversion is required to change between Modes 1 and 2 or between Modes 3 and 4. The mechanical conversion consists
of the following steps:
1. Change the Throttle Ratchet
2. Adjust the Elevator Centering Screw
3. Move the Throttle Limit Wedges

Changing the Throttle Ratchet

1. Disconnect the battery holder or optional battery from the
transmitter and set aside.
2. Remove the eight Phillips head screws that secure the rear
transmitter case half.
3. Put the transmitter face down on a piece of foam or a towel
and remove the rear case.
CAUTION:
Use care to not pull or disconnect any of the
wires attached to the back transmitter half.
4. Locate the silver throttle friction straps on both gimbals. One
strap engages a serrated section on the gimbal for a ratcheted
throttle, while the other strap engages the smooth section on
the gimbal.
5. To change the throttle ratchet, loosen the throttle strap so
it does not touch the throttle gimbal. Tighten the opposite
throttle strap to engage the desired throttle ratchet.
If you only need to adjust the throttle friction, see the Adjust
Throttle Friction Straps section.
40
SPEKTRUM DX6 • TRANSMITTER INSTRUCTION MANUAL




Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents