Install Column Support; Install The Table; Install The Drill Press Head; Install Handles - PowerTec DP800 Owner's Manual

WARNING
The drill press is designed to be safely assembled by at
least two people working together.

INSTALL COLUMN SUPPORT

Refer to Figure 2
• Place the base on the floor or a bench.
• Place column on the base.
• Align the holes and secure the column on the base with
3 long hex bolts and washers.
Figure 2
Column

INSTALL THE TABLE

Refer to Figure 3
• Locate the table assembly. Slide table assembly over
the column.
• Insert lock handle into the threaded hole at the rear of
the table assembly.
• To lock table in position, tighten lock handle to secure
table.
Figure 3
Table
Assembly

INSTALL THE DRILL PRESS HEAD

Refer to Figure 4
• Position and slide the head over the column.
• Carefully rotate the head on the column so it is aligned
with the base.
• Secure the drill press head with two lock set screws,
using the hex wrench.
Figure 4

INSTALL HANDLES

Refer to Figure 5
• Locate the three thread holes on the hub of the head.
Base
• Thread the handles into the holes of hub until tight.
Figure 5
Locking
Handle
HUB
3
HEAD
ASSEMBLY
SET
SCREWS
FEED
HANDLE