Table of Contents
Advertisement
5. FREQ
The "FREQ" key selects the testing frequency. Each press of
the key will select either 1kHz, 10 kHz, 100kHz, 100Hz or
120Hz, total 5 frequency for selection.
The default frequency setting is 1kHz.
- 22 -
The
testing
frequency is 1kHz.
Press "FREQ " key
testing
The
frequency is 10kHz.
Press "FREQ " key
The test frequency is 100kHz.
Press "FREQ " key
The test frequency is 100Hz.
Press "FREQ " key
The LCR impedance scale ranges are based on the test
frequency.
6.
Backlight
Press"
"key to toggle backlight on/off.
The backlight will be disabled in 60 seconds automatically from
the last operation of pushing any key or measurement.
7. SORTING / SETUP / ENTER
These key functions are disabled in LCR AUTO mode.
Press "LCR AUTO " key to select primary parameter
measurement function.
In measurement (connect DUT), press " SORTING " key to
enter the sorting mode which will be set to 2000 digits display
automatically. If the reading is OL or less than 200 counts, the
sorting function is disabled.
- 23 -
The test frequency is 120Hz.
Press "FREQ " key
Back to test frequency 1 kHz
Hide quick links:
Advertisement
Table of Contents
