Makita 12V 8413D Instruction Manual page 12

ASSEMBLY
Installing or removing driver bit or drill bit
CAUTION:
Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the bit
Turn the sleeve counterclockwise to open
the chuck jaws. Place the bit in the chuck
as far as it will go. Turn the sleeve clock-
wise to tighten the chuck.
To remove the bit, turn the sleeve counter-
clockwise.
When not using the driver bit, keep it in the
bit holders. Bits 45 mm (1-3/4") long can
be kept there.
Side grip (auxiliary handle)
Always use the side grip to ensure operat-
ing safety. Install the side grip
so
that the
teeth on the grip fit in between the protru-
sions on the tool barrel.
Then tighten the grip by turning clockwise
at the desired position. It may be swung
360" so as to be secured at any position.
I
Teeth
Grip base
Side grip
Loosen Tighten
12