Download Print this page
Garmin StreetPilot i2 Set Up And Go
Hide thumbs Also See for StreetPilot i2:

Advertisement

Quick Links

Getting Started

i2/i3 and mount
USB cable
Vehicle adapter cable
Insert Batteries
Tab
1. Press down on the tab and pull to remove the battery door.
2. Insert two AA batteries.
3. Press down on the battery door as you slide it back into place.
Keep batteries installed in your i2/i3 so it can find satellites quickly.
Set Up the i2/i3
Press and hold the
Power
turn on the i2/i3. Follow the instructions
on the screen to set up the i2/i3. Roll
the
Wheel
up and down to highlight
options. Press in to select options.
Install Software and Load Maps
Do not connect your i2/i3 to your computer until you are told to do so!
1. Insert the Setup DVD-ROM into your computer's DVD-ROM
drive.
If the welcome screen does not automatically appear, click
Start
and then
Run
on your personal computer. Type the
letter of your DVD-ROM drive followed by setup.exe (example:
D:\setup.exe). Then press Enter.
2. Follow the instructions on the screen to install software and
load maps to your i2/i3.
3. When MapInstall opens, click the map to select the regions you
want to load to your i2/i3. Selected maps are shaded pink.
NOTE:
Keep your Unlock sheet in a safe place for future reference.
Setup
Unlock sheet
DVD-ROM
button
to
Wheel
Power
Mount the i2/i3
Windshield
Lever
1. Place the suction cup mount on your windshield with the lever
pulled toward you, as shown above.
2. Press the lever toward the windshield.
3. Plug one end of the vehicle adapter into the USB port on the
i2/i3. Plug the other end into a receptacle in your vehicle.
WARNING:
For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the i2/i3 installed
to place and secure the device so it will not interfere with the vehicle operating controls and safety devices, obstruct the
driver's view of driving conditions, or cause personal injury in the event of an accident.
NOTICE TO STATE OF CALIFORNIA DRIVERS:
drivers in California should not use suction mounts on their windshield or side or rear windows. Other Garmin dashboard
or friction mounting options should be used. For available accessories, refer to the Garmin Web site at www.garmin.com.
Also, refer to the Owner's Manual for instructions on using the included mounting disk with the suction cup mount.
Find a Place and Go!
Select
Where To?
Select
and
More.
Select a destination.
Select
Tip:
To narrow your search, select the
the place.
USB port
California Vehicle Code Section 26708 (a) (1) provides that
Food, Hotels,
Select a category.
Start
Navigating.
Enjoy the route!
<Spell>
field and enter letters in the name of

Advertisement

loading

Summary of Contents for Garmin StreetPilot i2

  • Page 1: Getting Started

    California Vehicle Code Section 26708 (a) (1) provides that drivers in California should not use suction mounts on their windshield or side or rear windows. Other Garmin dashboard or friction mounting options should be used. For available accessories, refer to the Garmin Web site at www.garmin.com.
  • Page 2: Following Your Route

    For more information about your i2/i3, refer to the Owner’s Manual located If necessary, select Select the correct Select Start on the Setup DVD-ROM. You can also view it online at http://www.garmin. a city. address. Navigating. com/products/spi3 or spi2. Click the Manuals link and then select Download.

This manual is also suitable for:

Streetpilot i3