How To Use - Farberware CM3000S Use And Care Book Manual

Product may vary slightly from what is illustrated.

1. Cover
† 2. Permanent tea filter (Part # CM3000S-03)
† 3. Permanent coffee filter (Part # CM3000S-04)
† 4. Removable water filter (Part # CM3000S-01)
5. Easy-view water window
6. Blue backlit digital display
7. Control panel
8. Sneak-A-Cup® interrupt feature (coffee only)
† 9. Duralife™ glass carafe (Part # CM3000S-05)
10. Nonstick "keep hot" carafe plate
† 11. Removable filter basket (not shown) (Part # CM3000S-02)
12. Built-in cord storage (not shown)
Note: † indicates consumer replaceable/removable parts
4










How to Use

This product is for household use only.
GETTING STARTED
• Please go to www.prodprotect.com/applica to register your warranty and for
information about replaceable parts.
• Wash removable parts as instructed in CARE AND CLEANING section.
• Open cover and pour fresh cold water into the water reservoir up to 12-cup (MAX)
mark.
• Place permanent filter or paper 8 – 12 cup basket-style paper filter into filter basket
• Close cover.
• Make sure the carafe lid is in place and place empty carafe on the "Keep Hot" carafe
plate.
• Plug electric cord into an outlet.
• Brew water through appliance following the BREWING COFFEE instructions – without
adding coffee grounds.
• Discard water from the carafe; rinse permanent filter or discard paper filter.
• Turn off the appliance, unplug and allow it to cool down.
USING WATER FILTER
Note: Replace carbon filter every 60 brewing cycles (after using AUTO CLEAN cycle) or
every 2 months after removing it from the sealed package. Call 800 number on the front
cover for replacements.
1. Remove carbon filter from packing material.
2. Press latch on filter holder to open and place carbon filter inside.
3. Close the filter holder tightly until it snaps into place.
6. Place filter holder inside the water reservoir and insert it into the recess at the bottom
left corner.
REPLACING WATER FILTER
1. Press latch on filter holder to open.
2. Dispose of old carbon filter.
3. Remove new carbon filter from packing material.
4. Place new carbon filter inside filter holder.
5. Close the filter holder tightly until it snaps into place .
6. Place filter holder inside the water reservoir and insert it into the recess at the bottom
left corner.
SETTING THE CLOCK
1. Plug appliance into standard electrical outlet.
2. The digital clock display flashes 12:00.
Note: You must set the clock in order to use the DELAYED BREWING feature.
3. To change the time: Press HOUR button until the correct time appears on the display.
When the time passes noon "PM" illuminates to let you know you are in PM time.
If the "PM" is not illuminated it is AM time.
4. Repeat the same procedure with the MIN button to select the minutes.
Note: If the appliance is unplugged or power is interrupted even momentarily, the time
may need to be reset.
5