Troubleshooting - Carson x4 Micro Quadcopter Instruction Manual

p. Troubleshooting
Please read this before something happens.
Problem
The model does not move
Motor does not turn
The model reacts
incorrectly to the control
commands or flies
choppily
The model does not
take off
The rotors do not allow
shut down
The model moves forward/
backward and sidewise, but
does not hover
The model vibrates severely 1. Check whether the rotors run true
Transmitter and quadcopter
can not be binded
LCD transmitter not showing
the setting interface after
hold down the joystick for 1
seconds and take off again
Gyro not working well
Unable to Flip
Can not take off
White B
Black A
Cause
1. Check whether the transmitter and the receiver
are switched on
2. Check the battery voltage of transmitter and receiver
3. The trim slider of the throttle control stands on the
upper stop
1. Motor is defective
2. Motor is too hot
Check the state of the transmitter and receiver battery
charges
1. Rotor blades are twisted
2. Motor is too hot
3. Batteries are empty
Trim is not correctly adjusted
Check whether the quadcopter is exposed to a draught, e.g.
by an opened window or an air conditioner. Hover flight is
not possible when there is a draught
Throttle control not set to minimum
Throttle control not set to zero
1. Battery voltage is to low
2. Re-binding
3. Gyro resetting
1. Power not enough
2. Press the cyclic joystick one time to enter into the expert
(flip) mode
Wrong installation on rotors, rotors mark with A, B.
Front
Back
Reparation
Switch transmitter and/or receiver on
Employ completely charged batteries
Ensure that the trim slider is in neutral position
or somewhat below
Exchange the motor
Allow the motor to cool down
Employ completely charged batteries
Exchange the rotor blades
Allow the motor to cool down
Charge the batteries or exchange them
Correct the trim on the pitch controller
Close the window/door, switch off the air
conditioner or select a more suitable room
Possibly change the rotor blades
Throttle need to be minimized to zero
Set throttle control to zero
Fully charge battery
Switch transmitter and model on and off
Land on to the ground for 3 seconds and take off
again
Akku vollständig aufladen
In the expert (flip) mode, the sensitivity on each
channel should be above 90%, you can program
the sensitivity in setting, please check manual
article „f." Sensitivity set up.
Mount the propeller as shown below
White A
Black B
CARSON x4 Micro Quadcopter 500507056
GB
39