Installing The Sd Memory Card/Multimediacard - Pentax Optio S Operating Manual

Installing the SD Memory Card/MultiMediaCard

Battery/Card cover
This camera uses an SD Memory Card and MultiMediaCard.
Captured images are recorded on the SD Memory Card/
MultiMediaCard if a card is inserted (
or in the Built-in memory if no card is inserted (
monitor). Make sure that the camera is turned off before inserting
or removing the SD Memory Card/MultiMediaCard.
z
x
c
b
Approximate Number of Recordable Images and
Recorded pixels/Quality levels
Recorded pixels
2048 × 1536
1600 × 1200
1024 × 768
640 × 480
• The above table indicates the number of images when using a 16MB
SD Memory Card.
• The above table is based on standard shooting conditions specified by
PENTAX and may vary depending on the subject, shooting conditions,
capture mode, SD Memory Card, etc.
Downloaded From camera-usermanual.com Pentax Manuals
16
Open the battery/card cover.
Insert SD Memory Card/MultiMediaCard so the label
(the side with the
monitor and push the card in until it clicks.
Close the battery/card cover.
To remove the card, eject the card by pressing it in the direc-
tion indicated by the arrow and pull it out.
Quality levels
Best
(
7
11
26
57
SD Memory Card/
MultiMediaCard
icon on the LCD monitor),
symbol) is facing toward the LCD
Better
) ( )
13
20
47
89
To remove the card,
push and pull out
icon on the LCD
Good Movie images
(320 × 240)
( )
19
28 30 sec. × 3
sets
62
119