What To Do If - Westinghouse PHN768U User Manual

What to do if ...

Problem
The cooking zones will not
switch on or are not func-
tioning.
Acoustic signal sounds
when appliance is switch-
ed off
The residual heat indicator
is not displaying anything
The automatic warm up
function is not switching it-
self on
Acoustic signal sounds
and appliance switches it-
self on and then off again;
after 5 seconds another
acoustic signal sounds
is lit
and number are dis-
played
If you are unable to remedy the problem by following the above suggestions, please
contact your dealer or the Customer Care Department.
Warning! Repairs to the appliance are only to be carried out by qualified service
engineers. Considerable danger to the user may result from improper repairs.
Possible cause
More than 10 seconds have
passed since the appliance was
switched on
The child safety device is switched
on
Several sensor fields were touched
at the same time
Automatic switch off has been trig-
gered
The lock is switched on
The control panel is wholly or partly
covered by objects.
The cooking zone was only on for a
short time and is therefore not hot
There is still residual heat on the
cooking zone
The highest heat setting is set
The heat setting was set using the
sensor field
The On/Off sensor field has been
covered up, e.g. by a cloth
Overheating protection for the
cooking zone has been triggered
Automatic switch off has been trig-
gered
Electronics fault
westinghouse 11
Remedy
Switch the appliance on again.
Deactivate the child safety device
(See the section "Child safety de-
vice")
Only touch one sensor field
Remove any objects (pan, cloths,
etc.) that are lying on the control
panel. Switch the appliance on
again
Switch off the lock (See the section
"Locking/unlocking the control
panel")
Remove objects.
If the cooking zone is supposed to
be hot, call the Customer Service
Department.
Let the cooking zone cool down
The highest heat setting has the
same power as the automatic
warm up function
1. Switch off the cooking zone
2. Set the cooking zone using the
sensor field
Do not place any objects on the
control panel
Switch off the cooking zone.
Switch the cooking zone on again
Switch off the cooking zone.
Switch the cooking zone on again
Disconnect the appliance from the
electrical supply for a few minutes
(Take the fuse out of the house's
wiring system) If after switching on
again, is displayed again, call
the customer service department