Related Manuals for Qcells Q.Pro-G3
Summary of Contents for Qcells Q.Pro-G3
- Page 1 InstallatIon and operatIon Manual Q.Pro-G3 · Q.Pro BFr-G3 · Q.Peak-G3 · Q.Peak BLk-G3 · Q.PLUS-G3 Valid for North America...
-
Page 2: Table Of Contents
Note: Risk of damage to product Document Revision 03 This Installation Manual is valid for USA and Canada as of January 2015 for Q.PRO-G3, Q.PRO BFR-G3, Q.PEAK-G3, Q.PEAK BLK-G3 and Q.PLUS-G3 solar modules, and replaces all earlier versions. Technical parameters and the design are subject to change. The data sheets and customer information valid at the point in time when the relevant module was manufactured apply to the installation, mounting, and maintenance procedures for the respective solar modules. -
Page 3: Planning
Q CELLS. Q CELLS assumes no liability for damage resulting from LIMITED WARRANTY AND MAY CREATE A SAFETY HAZARD ProDUCT LINe Q.Pro-G3 / Q.PLUS-G3 Q.Pro BFr-G3 AND RISK PROPERTY DAMAGE. THIS INCLUDES IMPROPER failure to observe these instructions. INSTALLATION OR CONFIGURATION, IM PROPER MAINTENANCE, Please observe the wiring and dimensioning of the system. -
Page 4: Requirements
Avoid partial shading (for example through overhead lines, dirt, • Minimum angle of inclination: 3° Fig. 1: External dimensions in inch (mm) and components for Q.PRO-G3, Q.PRO BFR-G3, Q.PEAK-G3, Q.PEAK BLK-G3, Q.PLUS-G3 snow). • Maximum angle of inclination: 80° •... -
Page 5: Mounting Options
Mounting profile LoaD [Pa] aCC. IeC 61215 [Pa] 9.65 - 17.52 9.65 - 17.52 (245 - 445) (245 - 445) Q.PRO-G3 Push 9.65 - 13.58 (245 - 345) 3500 TyPe oF MoDULe PoINT MoUNTING SySTeM LINear MoUNTING SySTeM Q.PRO BFR-G3 13.62 - 17.51 (346 - 445) -
Page 6: Electrical Layout
PLaNNING 2.3 Mounting options PLaNNING 2.4 electrical layout Module Selection Parallel Connection For detailed key electrical data, please refer to the product data Modules may be damaged by the occurrence of reverse currents SPeCIFICaTIoN oF THe CLaMPING raNGe sheet for the respective product. (caused by module defects, ground leaks, or defective insulation). -
Page 7: Installation
INSTaLLaTIoN 3.1 Safety and transport INSTaLLaTIoN 3.1 Safety and transport Ä Ensure that all personnel are aware of and adhere ! Risk of fatal injury due to electric shock! ! Module damage may occur! ! Module damage may occur! DANGER NOTE NOTE to accident-prevention and safety regulations. - Page 8 INSTaLLaTIoN 3.2 Preparation of installation INSTaLLaTIoN 3.3 Module installation ! Risk of fatal injury due to electric shock! ! Risk of injury due to falling modules! Option 1: Ä Maintain an interval of at least 0.39 in (10 mm) DANGER WARNING Ä...
-
Page 9: Electrical Connection
eLeCTrICaL CoNNeCTIoN 4.1 Safety eLeCTrICaL CoNNeCTIoN 4.2 electrical installation safety DANGER! ! Risk of fatal injury due to electric shock! ! Risk of fatal injury due to electric shock! ! Risk of fatal injury due to electric shock! DANGER DANGER DANGER Risk of fatal injury due to electric shock! Never open the junction box. -
Page 10: After Installation
eLeCTrICaL CoNNeCTIoN 4.3 Connection of modules eLeCTrICaL CoNNeCTIoN 4.4 after installation Ä Use solar cables for the connection at the junction ! Module damage may occur! Ä Ensure that all necessary safety and functional ! Module damage may occur! NOTE NOTE box outlet. -
Page 11: Grounding
GroUNDING eLeCTrICaL CoNNeCTIoN In order to prevent electrical shock or fire, the frame of the module Q CELLS solar modules are known for a long operating ! Module damage may occur! NOTE as well as any non-current-carrying metal parts of the system must life and minimal maintenance effort and expense. - Page 12 ContaCt HanwHa Q CELLS USa Corp. 8001 Irvine Center Drive tEL +1 848 748 59 96 EMaIL q-cells-usa@q-cells.com Suite 1250 FaX +1 949 748 59 84 Irvine CA 92618 www.q-cells.us Subject to change without notice. © Hanwha Q CeLLS GmbH Installation manual G3 modules_2015-01_Rev03_NA...