Qcells Q.MAXX-G5 Series Installation And Operation Manual

Solar module

Advertisement

Quick Links

Installation and
operation manual
Q.MAXX-G5 solar module series

Advertisement

Table of Contents
loading

Summary of Contents for Qcells Q.MAXX-G5 Series

  • Page 1 Installation and operation manual Q.MAXX-G5 solar module series...
  • Page 2: Table Of Contents

    4.2 Electrical installation safety use of quality crystalline solar modules from Qcells and their systems. installation, mounting, wiring, maintenance and disposal. 4.3 Connection of modules Any international, country specific and regional accident- ■...
  • Page 3: Introduction

    1 Introduction 2 Planning 2.1 Technical specifications Validity For additional information see the relevant datasheet of the module provided at www.qcells.com/au/. These instructions are only valid for crystalline solar modules Q.MAXX-G5 Q.MAXX BLK-G5 from the company Qcells as specified at chapter "2.1 Technical PRODUCT LINE Q.MAXX-G5+...
  • Page 4: Requirements

    EUROPE Installation Site Forces acting on the module are relayed to the mounting Fig. 2: Installation options for crystalline Qcells modules. All dimensions are given in mm. Also observe the maximum test loads and ■ ASIA substructure. clamping range as specified on the following page.
  • Page 5 2 Planning 2 Planning 2.3 Mounting Options 2.3 Mounting Options Installation Site MOIUNTING REQUIREMENTS OPTION MOUNTING TEST LOAD DESIGN LOAD SAFETY The loads in the table are related to the mechanical stability of the solar modules. The mechanical POSITION OF CLAMPS* [MM] OPTION PUSH / PULL** [Pa] PUSH / PULL** [Pa] FACTOR stability of the mounting system including clamps has to be evaluated by the system supplier.
  • Page 6: Electrical Layout

    Modules may be damaged by the occurrence of reverse currents accident-prevention and safety regulations. Do not install damaged modules. sheet referring to the relevant Module (available at www.qcells. (caused by module defects, ground leaks, or defective insulation). While working wear clean gloves.
  • Page 7: Preparation Of Installation

    Do not carry out the installation alone. Do not drop modules. Only make modifications to the module which have Only use dry, insulated tools. been confirmed in writing by Qcells. confirmation letter Note! Module damage may occur! Note! Module damage may occur! Danger! Risk of fatal injury due to electric shock! Only install undamaged modules and components.
  • Page 8: Module Installation

    3 Installation 4 Electrical Connection 3.3 Module installation 4.1 Safety Danger! Option 1: Danger! Risk of fatal injury due to electric shock! Maintain an interval of at least 10 mm between two Risk of fatal injury due to electric shock! modules along the short side and 5 mm along the Fasten the module with 4 clamps in the specified Never open the junction box.
  • Page 9: Electrical Installation Safety

    4 Electrical Connection 4 Electrical Connection 4.2 Electrical installation safety 4.3 Connection of modules Danger! Risk of fatal injury due to electric shock! Danger! Risk of fatal injury due to electric shock! Note! Module damage may occur! Use solar cables for the connection at the junction box outlet.
  • Page 10: After Installation

    Do not attempt to fix any problems yourself (e.g., glass cracks, from any water-channelling surface. damaged cables). Please contact an installer or Qcells Technical Customer Service Department. 7 Disposal Do not disconnect modules by yourself. Please contact an installer or Qcells Technical Customer Service Department.
  • Page 11: Maintenance And Cleaning

    8 Maintenance and cleaning NOTE! Qells solar modules are known for a long operating life and minimal maintenance effort and expense. Dirt and grime are Dust and dirt are abrasive materials! usually washed away by rain. If the module is fully or partially The situation for each individual project (or type of dirt) must shaded by dirt or debris (e.g., plants, bird droppings), it needs always be professionally evaluated.
  • Page 12 HANWHA Q CELLS AUSTRALIA PTY LTD EMAIL inquiry.aus@qcells.com +61 (0)2 9016 – 3033 Suite 1, Level 1, 15 Blue Street North Sydney, NSW 2060 Australia www.qcells.com/au/ Subject to change without notice. © Qcells Installation manual solar modules Q.MAXX-G5_2023-03_Rev02_AU...

This manual is also suitable for:

Q.maxx-g5Q.maxx blk-g5

Table of Contents