Table of Contents
Related Manuals for KERN TEB
Summary of Contents for KERN TEB
- Page 1 KERN & Sohn GmbH Ziegelei 1 Tel: +49-[0]7433- 9933-0 D-72336 Balingen Fax: +49-[0]7433-9933-149 E-Mail: info@kern-sohn.com Internet: www.kern-sohn.com Operating instruction Pocket balance KERN TEB Version 1.0 10/2005 TEB-BA-e-0510...
-
Page 2: Table Of Contents
KERN TEB Version 1.0 10/2005 Operating instruction Pocket balance Table of contents: Declaration of conformty ------------------------------------------------------------------------------- 3 Technical data---------------------------------------------------------------------------------------------- 4 Fundamental information (general) ----------------------------------------------------------------- 4 Intended use------------------------------------------------------------------------------------------- 4 Inappropriate use------------------------------------------------------------------------------------- 4 Guarantee ---------------------------------------------------------------------------------------------- 5 Monitoring the test substances ------------------------------------------------------------------- 5... -
Page 3: Declaration Of Conformty
Compatible norms are, in particular Standards for electronic scale. EN 61000-6-3 :2001 EN 61000-6-1 :2001 If a change is made to the above mentioned appliances without consulting KERN this declaration will become invalid Date: 01.10 2005 Signature: Gottl. KERN & Sohn GmbH Management Gottl. -
Page 4: Technical Data
Structural alterations may not be made to the balance. This can lead to incorrect weighing results, faults concerning safety regulations as well as to destruction of the balance. The balance may only be used in compliance with the described guidelines. Varying areas of application/planned use must be approved by KERN in writing. TEB-BA-e-0510... -
Page 5: Guarantee
For this purpose, the answerable user must define a suitable interval as well as the nature and scope of this check. Information is available on KERN’s home page (www.kern- sohn.com) with regard to the monitoring of balance test substances and the test... -
Page 6: Unpacking, Installation And Commissioning
Major display deviations (incorrect weighing results, or a failure function of the calcu- lator) are possible if electromagnetic fields occur as well as due to static charging and instable power supply. It is then necessary to change the location. TEB-BA-e-0510... -
Page 7: Unpacking
It is also recommendable to adjust the balance periodically during weighing operation in order to obtain exact measured values. TEB-BA-e-0510... -
Page 8: Adjusting
Only now (!) place object on the weighing pan. Make sure that the weighing object does not stripe or touch the housing or base. If the object should be heavier than the weighing range allowance, the symbol “E” (overload) will appear on the display . TEB-BA-e-0510... -
Page 9: Taring
Weigh component , by pressing the key the net-total is displayed, this means the sum of the components If necessary fill the formula container up to the desirable level. To return to the weigh- ing mode press the TEB-BA-e-0510... -
Page 10: Unit Change
Remove any spilt material to be weighed immediately. Maintenance, upkeep The device may only be opened by trained service engineers authorised by KERN. Disposal The operating company shall dispose of the packaging and the device in compliance with the valid national or regional law of the operating location. -
Page 11: Troubleshooting
• Electromagnetic fields / static charging (choose different location/switch off inter- fering device if possible) Switch the balance off if other error messages should appear and then switch on again. Contact the manufacturer if the error message does not disappear. TEB-BA-e-0510...