Whirlpool EDI9MT Use And Care Manual page 7

Removing freezer bin.. .
For proper air movement, keep the freezer bin In
place when the refrigerator is operating.
To remove the bin:
To replace the bin:
l
Slide out to the stop.
l
Place bin on the slides.
l
Lift the front to clear the stop.
l
Make sure the stops clear
l
Slide out the rest of the way.
the front of the slides.
l
Slide bin in.
Using automatic ice maker
and Tilt Ice* Dispenser.. .
l
You will hear water filling the mold and Ice cubes
There are a few things you'll want to know about
falling into the bin. These are normal sounds.
the ice brn and the automatic ice maker that fills it.
l
The ice maker will stop automatically when the bin
I'
l
Brn is inside small door
is full. It will start again when you remove Ice.
on freezer door
l
Shake bin occasionally to keep cubes separated.
3
l
To open Tilt-Ice*
Dispenser Door, lift
up on handle, tilt
door down.
l
Reach in, pull bin out
II
part way or remove it
from freezer.
l
If you remove bin,
STOP ice maker. Open
freezer door and push
lever to OFF Push
it back ON when you
Changing the light bulbs.. .
WARNING: Before removing a light shield for
_ . .
Cleaning
or
tOr
replacing the bulb,
either unplug refrigerator or discon-
nect electricity leading to re-
frigerator at the main power supply.
Shock and injury can occur if eiec-
tricity remains connected.
Tips
l
New plumbing connections can give the first
cubes an odd taste or color. Just throw these
away. The ice maker will refill the bin.
l
Cubes stored too long may develop an off-
flavor...like stale water. Throw them away.
l
Cubes stored for more than a few weeks will
become smaller because moving air in the
freezer is so cold that it starts a slow evapo-
ration. If you use ice often, you may never
notice shrinkage.
l
Good water quality is important for good ice
quality. It is not recommended that the ice
maker be connected to a softened water sup-
ply. Water softener chemicals such as salt from
a malfunctioning softener can damage the
ice maker mold and lead to poor quality ice. If
a softened water supply cannot be avoided,
then it is important that the water softener be
well maintained and operating properly.
light bulbs behind refrigerator and freezer con-
trol consoles:
1 Pull control knob straight off.
2 Pull bottom of control panel straight out
3 Lift top of panel off supports
4 Replace with a 40.watt appliance bulb.
5 Replace panel in reverse order.
light bulb behind ice maker:
1. Remove the Ice bin [see ice maker Instructions
2. Replace with a 40.watt appliance bulb
3 Replace ice bin.
I
'IlIly / 'III"'
I
Pull Off the Dial;
Pull Out at the Bottom
'TMK