Table of Contents
Advertisement
Front Panel
1
2
1 Input Signal Indicators
A set of three pairs of LEDs indicate signal present, +4dBu and input clip for each channel. The signal
present LEDs operate at approximately 40 dBu, giving a useful indication of even relatively low input
signal levels. The +4 dBu LEDs are intended to show nominal operating level and can also be useful
for setting system gain structure. Clip LEDs warn the user of input overload and operate at +19 dBu.
2 Preset Store and Recall
These controls provide access to the 45 presets stored within the device. Pressing the store button
allows the user to name a preset and choose which memory location it will be held in. Pressing store
button again completes the process. The Recall function operates in a similar way, pressing the recall
button allows the user to select which preset they require, pressing the button for a second time, then
confirming, recalls the new DSP settings.
Note that presets cannot be stored or recalled when Secure mode is activated.
3 Channel Select Buttons
The currently selected channel is displayed on the top left hand corner of the LCD. Pressing the
channel buttons scrolls through the available input and output channels and finally through the utility
functions and back to the default screen. If operating a stereo linked preset, the channel name will
indicate the channel pairing. For example 'A+B' means both input A and B parameters. The name of
the output will be shown briefly at the top of the display when stepping onto an output.
4 Edit Select Buttons
The currently selected edit parameter page is displayed on the bottom left corner of the LCD.
Pressing the edit select buttons moves through the available parameters for the current input or
output.
5 Text Display
Preset, channel, parameter and status information is shown on the 2x 24-character text display. In
most screens the currently selected channel is displayed on the upper line and the edit parameter on
the lower line. To simplify the display and enhance security, some parameters or parameter pages
are omitted when not relevant.
6 Parameter Knobs
Three velocity sensitive parameter knobs are used to adjust parameters shown on the display. Up to
three parameters at a time are displayed on the screen. The parameter name is shown above the
parameter value in each of the three screen sections. The parameter knobs have a fixed association
with the screen sections; the rightmost parameter knob adjusts the rightmost parameter and so on.
6
3
5
4
7 7
6
6
6
8 8
7 7
7 7
8 8
8 8
Hide quick links:
Advertisement
Table of Contents
