Pride Mobility GOPHER Owner's Manual page 17

5 . B AT T E R Y C H A R G I N G A N D C A R E
■ Cleaning the battery
If the batteries are contaminated by water, battery acid, dust or other substances, they will
discharge quickly. The batteries supplied with the WU‟S scooter are sealed and as such are
maintenance free with no risk of battery leakage. Please follow the steps below to clean the
battery.
1. Turn the scooter power switch to "OFF".
2. Remove the seat and dust cover.
3. Remove the shroud and unplug the terminal of the taillight and signal lights.
4. Use a clean cloth to wipe off the soiled area.
5. Take out the battery.
6. Clean the battery with a clean cloth. If the terminal is covered by white powder, please wipe
it clean using warm water.
 Warning
1. The wiring system and charger are well situated in battery pack while assembled in plant.
Do not attempt to re-locate the wiring system by yourself. The improper layout of wiring
system may result in the wires pinched by battery box, which might the electronic system
failure.
2. Be sure the battery wires are connected to their right battery terminal.
 Suggestions
If necessary, ask for help from your dealer for advice about maintaining and replacing the
battery.
 Suggestions
1. Make sure the terminals are installed properly and put the cover back on.
2. Do not use the battery to charge telecom equipment or other items.
3. Battery efficiency will vary with outside conditions; the driving distances will be shorter in
the winter. If the vehicle is not used for a long time, please charge the battery at least
every week.
4. Replace both batteries together.
16