Table of Contents
Advertisement
5. Caution label attachment
1)
Attach the caution label (package part No. 5) near a AC power
cord inlet of the main unit.
6. Turn on the power switch of the print
controller unit and the main unit
1)
Insert the power plug of the print controller unit into the power
outlet.
2)
Insert the power plug of the main unit to the outlet.
3)
Turn on the power switch of the print controller unit.
ON
MX-PEX2 Installation in MX-3500/4500 series 2 – 3
4)
Open the front cabinet. Turn ON the power switch in the front
cabinet of the main unit.
5)
Turn ON the power switch on the operation panel.
7. Note for network setting and
calibration resetting
CAUTION:
CAUTION: After the MX-PEX1/PEX2 is installed, be sure the
setting of items as follows again.
(Reconfiguration in setting is required, because the
information that had been keeping before installa-
tion is initialized.)
System setting → Printer Setting (administrator area) → Fiery
1)
Setting → Carry out the initial setting from Fiery menu.
After the initial setting and automatic reboot → Printer Setting
2)
(administrator area) → Fiery Setting → Carry out the calibra-
tion from Fiery menu again.
A. About the Fiery Setting
Refer to the configuration manual "SETTING UP THE FIERY
X3ETY2 FROM THE COPIER TOUCH PANEL".
B. About the calibration
Refer to the color printing manual "Calibration".
1)
To execute the calibration from the touch panel of Copier, refer
to the "Calibrating from the Fiery X3eTY2 copier touch panel".
2)
To execute the calibration with a color measurement meter,
refer to the "Calibrating with ColorWise Pro Tools Calibrator".
ON
ON
ON
Advertisement
Table of Contents
