Safety Instructions - g-lites Titanum 15R User Manual

9. SAFETY INSTRUCTIONS

Be careful with your operations. With a dangerous voltage you can suffer a dangerous
electric shock when touching wires!
This device has left the factory in perfect condition. In order to maintain this condition and to ensure a safe
operation, it is absolutely necessary for the user to follow the safety instructions and warning notes written in
this user manual.
1. In order to guarantee the product's life, please don't put it in the damp places or even the environment
over 60 degress.
2. Always mount this unit in safe and stable matter.
The qualified professionals are allowed to carry out the lamp installation, operation and maintenance, but
they must guarantee to operate in strict accordance with the instructions referred to.
3. Using lamp, the change rate of power voltage should be within±10%, if the voltage is too high, it will
shorten the light's life; if it's not enough, the lamp will be dark.
4. Please restart it after turning off light for 20 minutes until full-cooling. Frequent switching will reduce the
life span of lamps and bulbs; intermittent using will improve the life of bulbs and lamps.
Important:
▲
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will
not accept liability for any resulting defects or problems.
If the device has been exposed to temperature changes due to environmental changes, do not switch it on
immediately. The arising condensation could damage the device. Leave the device switched off until it has
reached room temperatures.
This device falls under protection-class. Therefore it is essential that the device be earthed.
The electric connection must carry out by qualified person.
Make sure that the available voltage is not higher than stated at the end of this manual.
Make sure the power cord is never crimped or damaged by sharp edges. If this would be the case,
replacement of the cable must be done by an authorized dealer.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power cord by the plug. Never pull out the plug by tugging the power cord.
During initial start-up some smoke or smell may arise. This is a normal process and does not necessarily
mean that the device is defective, it should decrease gradually.
Please don't project the beam onto combustible substances.
If the external flexible cable or cord of this luminaries is damaged, it shall be exclusively replaced by the
manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
CAUTION!
CAUTION!
Never touch the device during operation!
The housing may heat up!
16