B. REMOVING THE OUT CASE AND
INNER COVER (Figure 8-a, 8-b)
(1) Remove the vent grille by removing two screws
securing it to the out case.
(2) Remove two screws securing it to the air duct.
(3) Remove the mounting plate by turning the screws
(1 or 2 screws) securing it to the out case.
(4) Remove three screws on the left central edge and
three screws on the right central edge of Base
plate. Remove the Mount, All from the out case by
removing one screw securing it to the out case.
(5) Remove six screws of the rear cavity.
Door
Vent Grille
Figure 8-a
Inner Cover
Figure 8-b
(6) Remove the outcase with disconnecting power
cord connector.
(7) Remove eight screws securing to oven cavity.
(8) Remove both sides inner cover with lifting up.
Mount, All
Controller
7-5
Power code
Mounting
Plate
Out Case
Inner Cover