Kodak EasyShare C663 User Manual page 51

Status
Pictures remaining
number does not
decrease after taking
a picture
Flash does not fire
Storage location is
almost or entirely full
Battery life is short
You cannot take a
picture
Error message
appears on LCD
www.kodak.com/go/support
Solution
Continue taking pictures. The camera is operating normally.
(The camera estimates the number of pictures remaining after each
picture is taken, based on picture size and content.)
Check the flash setting and change as needed
NOTE: The flash does not fire in all modes.
Transfer pictures to the computer
the card (page 12) or insert a new card.
Change image storage location to internal memory
Make sure the correct battery type is installed
Wipe the contacts with a clean, dry cloth before inserting a battery
in the camera.
Insert a new or charged battery.
Turn the camera off, then on again. Make sure the camera is not in
Favorites mode.
Depress shutter button all the way
Insert a new or charged battery
Wait until the Ready light turns green before attempting to take
another picture.
Memory full. Transfer pictures to the computer
pictures (page 12), change image storage location
insert another card.
Turn the camera off, then on again.
Remove memory card from the camera.
Remove the battery and wipe the contacts with a clean, dry cloth.
Insert a new or charged battery
If problem still exists, get help
Troubleshooting
(page
(page 14). Delete pictures from
(page
(page 6).
(page 2).
(page
(page 2).
(page 49).
20).
(page 31).
2).
14), delete
(page 31), or
45