Do you have a question about the Sx-E8(l) and is the answer not in the manual?
Questions and answers
Daniel Nechifor
April 9, 2025
Bună dimineața dețin o astfel de orgă electrică. Am o problemă la aceasta. Cablul care realizează legătura între claviatură și partea de pedalier și difuzor este lipsă. Vreau să î-l înlocuiesc cu un cablu euroscart, problema este că culorile la firele componente nu coincid cu cele ale mele, doresc o schemă de conexiune în acest scop. Vă mulțumesc anticipat.
1 comments:
Mr. Anderson
May 14, 2025
The Technics SX-E8(L) uses a 25-pin D-sub cable to connect the keyboard to the pedalboard/speaker unit. This cable carries power, audio, and control signals between the upper keyboard section and the lower pedal/speaker unit.
If the original cable is missing, you need to replace it with a DB-25 male-to-male cable wired in a straight-through configuration. This means that pin 1 on one end connects to pin 1 on the other end, pin 2 to pin 2, and so on through pin 25.
Connection scheme:
- Use a standard DB-25 male-to-male straight-through cable. - Do not use a null-modem or crossover cable, as this will not work. - Ensure all 25 pins are present and connected straight through.
Using an incorrectly wired cable can damage the instrument or cause it not to function properly.
Need help?
Do you have a question about the Sx-E8(l) and is the answer not in the manual?
Questions and answers
Bună dimineața dețin o astfel de orgă electrică. Am o problemă la aceasta. Cablul care realizează legătura între claviatură și partea de pedalier și difuzor este lipsă. Vreau să î-l înlocuiesc cu un cablu euroscart, problema este că culorile la firele componente nu coincid cu cele ale mele, doresc o schemă de conexiune în acest scop. Vă mulțumesc anticipat.
The Technics SX-E8(L) uses a 25-pin D-sub cable to connect the keyboard to the pedalboard/speaker unit. This cable carries power, audio, and control signals between the upper keyboard section and the lower pedal/speaker unit.
If the original cable is missing, you need to replace it with a DB-25 male-to-male cable wired in a straight-through configuration. This means that pin 1 on one end connects to pin 1 on the other end, pin 2 to pin 2, and so on through pin 25.
Connection scheme:
- Use a standard DB-25 male-to-male straight-through cable.
- Do not use a null-modem or crossover cable, as this will not work.
- Ensure all 25 pins are present and connected straight through.
Using an incorrectly wired cable can damage the instrument or cause it not to function properly.
This answer is automatically generated