Table of Contents
Advertisement
6.
Serial ATA 3.0Gb/s connectors (7-pin SATA3G [blue])
This connector connects to Serial ATA 3.0 Gb/s hard disk drive or optical drive via
Serial ATA 3.0 Gb/s signal cables.
C8HM70-I
C8HM70-I SATA 3.0Gb/s connector
•
•
•
7.
Serial ATA 6.0Gb/s connectors (7-pin SATA6G [gray])
This connector connects to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0 Gb/s
signal cables.
C8HM70-I
C8HM70-I SATA 6.0Gb/s connector
•
•
1-12
SATA3G_1
You must install Windows
hard disk drives.
To configure the default SATA type in BIOS, click Advanced Mode > Advanced tab >
SATA Configuration > SATA Mode Selection.
When using hot-plug and NCQ, set the SATA Mode Selection item in the BIOS to
[AHCI]. See section 2.5.3 SATA Configuration for details.
SATA6G_1
You must install Windows
hard disk drives.
When using hot-plug and NCQ, set the SATA Mode Selection item in the BIOS to
[AHCI]. See section 2.5.3 SATA Configuration for details.
XP Service Pack 3 or later version before using Serial ATA
®
XP Service Pack 3 or later version before using Serial ATA
®
Chapter 1: Product introduction
Advertisement
Table of Contents
